Skip to main content

@taqueria/plugin-octez-client

The Tezos Client plugin provides tasks to analyze contracts including type checking and simulating of Michelson (.tz) smart contracts. They both execute against a protocol (currently kathmandu). We'll enable a --protocol flag in the future to allow users to specify a protocol to use

Requirements​

  • Taqueria v0.26.0 or later
  • Node.js v16.16 or later. (v17.x.x or later is not supported)
  • Docker v20.10.12 or later

Installation​

To install the Tezos Client plugin on a Taqueria project, navigate to the project folder and run:

taq install @taqueria/plugin-tezos-client
note

You can override the Tezos-Client version used by the plugin by creating the environment variable TAQ_TEZOS_CLIENT_IMAGE and setting it to your desired Tezos-Client Docker image

The taq typecheck task​

Basic usage is:

taq typecheck <contractName>

Basic description​

This task typechecks a Michelson file in artifacts and reports a failure or success

The taq typecheck-all task​

Basic usage is:

taq typecheck-all

Basic description​

Performs the same function as taq typecheck, but performs type-checking for all contracts in the artifacts directory.

The taq simulate task​

Basic usage is:

taq simulate <contractName> <--param paramFileName>

Basic description​

This task runs a Michelson file in artifacts as a simulation and ouputs a result suggesting a failure or success. If it's a success, it shows the updated storage value, emitted operations, and big map differences

Options​

  • By default, the storage file it will use to simulate the contract is CONTRACT.default_storage.tz where CONTRACT is the name of the contract. If you wish to specify another storage file in artifacts, use the --storage flag

  • The --param flag is mandatory and you must supply the filename, in artifacts, that contains the actual parameter value

  • By default, the entrypoint is default, which points to no specific annotated entrypoint. Use --entrypoint to specify an annotated entrypoint to call. E.g. if the parameter type of a Michelson contract is (or (or (int %decrement) (int %increment)) (unit %reset)), then there are two ways to call the increment entrypoint, with parameter (Left (Right 14)) or with parameter 14 if your command contains --entrypoint increment

The taq client task​

Basic usage is:

taq client --command <command to pass to the underlying octez-client binary>

Wrap the value for the --command flag with quotes.

note

This task allows you to run arbitrary octez-client native commands, but they might not benefit from the abstractions provided by Taqueria

Plugin Architecture​

This is a plugin developed for Taqueria built on NodeJS using the Taqueria Node SDK and distributed via NPM